The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
We are noticing that as our 635 header comes out of draws or over terraces if a sensor hits the ground the whole header will get to bouncing, as many as 8 to 10 times before it settles back down, has anyone else experienced this?
 

·
Registered
Joined
·
19 Posts
Yes had exactly that on a 9670 and it was as farmerjones suggested the potentiometer. It wasn't loose though it was just faulty. If I remember rightly there is another one the same on the header somewhere (maybe on the concave??) that we swapped over to determine if that was the problem.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top