The Combine Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·

I have a problem in my 6610 forage harvester. When I want to start automatic knife sharpening cutterhead start to rotating for couple of seconds, then 228E error appears on Info-Trak monitor.

228E Desired program cannot be activated because cutterhead is not rotating. Turn Iron-Gard switch (S39) off, try again. Check if solenoid valves for pressure build-up and for reverser motor are correctly supplied with current. The cause could also be a hydraulic problem. Should the message appear although cutterhead is rotating, check cutterhead speed sending unit and wiring (see Section "Feeding System"). Check manual switch (S53) below cab.

I have checked all connections, stone moves in manual mode. Speed sending unit also is OK - it indicates correct rpm.

Is it normal that solenoid valve works like on linked video ?

Thanks in advance
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.