The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Anyone know of a company that sells a feeder house tilt kit or have any ideas on how to tip the head forward more? I have all the knife tilt bolts under the header screwed right up and the head seems to cut low enough but it only rides on the very back edge of the poly and wears though, then the poly flaps and looks like heck. Any other advice or ideas would be appreciated, I've tried everything in the operators manual and I think the next step is the feeder house. Thanks Shanty
 

·
Registered
Joined
·
80 Posts
Deere sells a tilt kit it's two brackets that bolt on the head on the top beam. They move the top pick up point back 4- 5 in.
 
1 - 3 of 3 Posts
Top