The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
The seperator won't engage on my 9500. It was on the last field and all of a sudden it won't turn on. I checked the relays and blew out the circuit board. I blew out the harnesses on the right hand side. What next?
 

·
Registered
Joined
·
56 Posts
Double check all the connectors on the right side of the cab and make sure all the pins are pulled out so they are making proper contact. I had the same type of problem on a 9610 and after a lot of checking and swearing it was just a pin not making good contact.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top