The Combine Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
205 Posts
Discussion Starter · #1 ·
Wondering what size and spline the shafts are on the 7010 feederhouse to run the header. We are going to be running a JD 1293 cornhead on it this fall. Thanks for the help in advance.
 

·
Registered
Joined
·
2,199 Posts
I've also head of Bish header adapters. If you want the field tracker stuff to work, I think you have to use a HeadSight to convert the sensor signals.

-Lance
 

·
Premium Member
Joined
·
205 Posts
Discussion Starter · #4 ·
Thanks for the help. I did get a hold of headsight, and they have what i need for the header height sensors. We used to run this head on our 2188 and i have shafts for that, but assume that the 7010 doesn't have the same 'hex' shaft as the 2188 did. I believe i can just put a new yoke on one end to match the 7010.
 

·
Registered
Joined
·
619 Posts
7010/8010 have a 6 spline drive shaft on the feeder, identical to a regular 540 rpm pto shaft. Couldn't be made any easier to adapt than that.
 
1 - 5 of 5 Posts
Top