The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
The head calibrates OK and when button 2 is selected (AHC) the head goes down and stops at the correct position but will not respond and go up or down when it should. i.e it is not sensing AHC commands. Button 1 works as it should. The contour master can not function as a result and is very slow. All sensor voltages are in range.HELP!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top