The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 · (Edited)
This tractor started making a noise ripping with a homebuilt 9 shank v ripper. it only makes the noise turning right. when you shift up or down it takes 10 to 15 seconds to shift. your in a gear you shift up or down then it stops and have to clutch or wait then it jumps. this tractor has 7181 hours as of 20 mins ago. it started about 3 weeks ago and havent used it since. thinking of selling and getting a john deere 8870 that is in great condition and has 7500 hours. good bad on these tractors. help on what the 8400ts problem is and how are 8870s. thanks in advance Ray
 

·
Registered
Joined
·
74 Posts
Are you getting any hyd system codes? It sounds like it could be a lack of flow- check hyd filters, pump could be on the way out, cracked pipe from main hyd pump to clean oil res in the back end. Are you turning with the ripper in the ground?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top