The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
125 Posts
Discussion Starter #1
Hi there wondering if any of you have had the sco 60 code on a 9400 series tractor or the like .

It only comes up sparaticly but still an issue. We had a tech out in the winter to track it down he had a hard time to get the code to pop up and couldn't find bare wires. I had him change the armrest circuit as a precaution. He was pretty positive it wasn't the board but I thought it was cheaper than another service call etc.
Hopeing some has had the problem and it's a matter of just looking at the wiring in a specific spot.
 

·
Registered
Joined
·
125 Posts
Discussion Starter #2
Bump

Still intermittent issues with this code .
Pain in the ass to seed .kicks out the fan have to restart tractor to clear it.

Techs replaced the armrest controller and have been over the wiring twice looking for issues
 

·
Registered
Joined
·
125 Posts
Discussion Starter #3
After couple service calls and a trip to the dealer there was 9 bad pins in a connector in the armrest . If you get the problem intermittently I would have them check/ change those right off the bat .
Will save you lots of cash
 
1 - 3 of 3 Posts
Top