The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have recently purchased an 04 2388 with a 30 2062 header, on the maiden voyage today I was not getting a reading for the tailings bar or a change in the header height number, the up and down arrows would come on however the number would not change, any help would be great I am a new case IH harvester owner.
 

·
Registered
Joined
·
3,334 Posts
grab ur operators manual and do a feeder height calibration..

with head off go somewhere where the feederhouse will go really far down.... when ur done all the way up should be.....um....I think in the 60's....64 is all the way up maybe?? sorry its been a year..

if that doesn't help im guessing ur height petintiometer (sorry on spelling) is bad and needs replaced.... that's common it seems like...

not sure on tailings....u might open the door on the tailing and take a long screw driver and hit the lever and have someone watch and see if it reacts. if not switch is bad....those are fun to replace by the way..
 
1 - 2 of 2 Posts
Top