The Combine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
247 Posts
Discussion Starter · #1 ·
What is the procedure for leveling concaves? I put the front one in and adjusted setting until it "ticked" and backed it off a tiny bit so it didn't. Then I put #3 in and the concave more than "ticked". I figure I need to do some adjusting here but am not sure of the correct way to do it.
 

· Registered
Joined
·
247 Posts
Discussion Starter · #6 ·
Back to the original question. How level concaves from front to back. I know there is an adjusting bolt on the front end of the concave hanger but how do you determine what is 'level'.
 

· Registered
Joined
·
247 Posts
Discussion Starter · #11 ·
Manual for 2144 doesn't describe it. Manual for 2588 is in combine which is in dealer's shop. Manual for 6088 is in my son's truck which is sitting in Minnesota. I guess I'll wait til he gets home later in the week.

Thanks guys.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top