The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,084 Posts
Discussion Starter #1
When I engage the thresher the cylinder pump seems jumpy when first getting up to speed. My 9790 doesn’t do this but this one seems to. At idle it gets it spinning then belts bounce just a bit once it backs off at speed. Is this normal? Might be that it set to keep rotor rpm aggressively maybe?
 

·
Registered
Joined
·
1,084 Posts
Discussion Starter #3
Thanks I figured it was normal. GTA monitor wasn’t working for some reason. Undid the connector at the back and plugged it in and it took off. Anyone know if these monitors are a pita
 
1 - 3 of 3 Posts
Top