The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
238 Posts
Discussion Starter · #1 ·
I have a 525 flex header ( not lateral tilt ) that the main drive shaft is bent. It's too close to the pulley to heat and straighten. None of the salvage yards nearby have much Gleaner and none have the drive shaft. Anyone know where I can find a used one send me a message or leave a post. Part number is 71368224
Matt
 

·
Registered
Joined
·
158 Posts
I'd have a shaft out of a parted out 525 but it's for a lateral tilt head so you'd need a shrt pto shaft. Located in Nw mn
 

·
Registered
Joined
·
238 Posts
Discussion Starter · #3 ·
It'd take about a 5' pto shaft wouldn't it? How much do you think you would have to have for it? We're pretty far apart geographically but that's nothing fed ex couldn't handle I suppose
 
1 - 3 of 3 Posts
Top