The Combine Forum banner

MacDon on a 590R

4299 Views 16 Replies 7 Participants Last post by  SouthernSK
Has anyone ever removed some flighting and added fingers to the feeder drum
to help the feederhouse run full and perhaps feed the cylinder more evenly and not crowd the center?
1 - 3 of 17 Posts
Never jumped a chain yet, only 2 years experience though. Tried a Lexion head to start and the first thing Tech did was to remove extra flighting on auger so it did not extend so far.
Kind of hard to take a plasma cutter to a nearly new MD. Will check MacDon service and stripper bars as suggested.
1 - 3 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.