The Combine Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
209 Posts
Discussion Starter · #1 ·
This question got buried in another post of mine somehow, but someone else told me to tilt my sieve a little bit, because all the corn was overloading the right side. How can i do that and how much do you recommend? 1', 2' maybe?
 

·
Registered
Joined
·
61 Posts
On your pro 600 monitor go to the main menu then choose Toolbox then at the bottom pick the tab that says clean. On this page there should be a listing for Sieve offset. Start out with 1 degree and if that doesn't work increase it a little more. You might also want to check that your concaves are shifted all the way to the right. There are 8 bolts you loosen and use the adjustment bolts to drag it to the right.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top