The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have purchased a 2004 9790 and am seeing the following messages on the LCD screen of the Electronic Instrument Panel.
The display switches between displaying HGT ERR and HDR CTRL. I have been unable to find this in rather operators manual. Any help will be greatly appreciated.
 

·
Registered
Joined
·
1,536 Posts
Header Control Height Error. I would guess that this is your feeder position sensor.
 

·
Registered
Joined
·
90 Posts
Have you calibrated your header check your voltages on the screen check there min and max they should be .5 min and 4.5 max and lower or higher it will say that or if the position is out of what the calibration is
 
1 - 4 of 4 Posts
Top