The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
236 Posts
Discussion Starter #1
Has anybody come up with anything to keep the moisture sensor from plugging up if you run some weeds through? Especially water hemp. Other than not having weeds.
 

·
Registered
Joined
·
22 Posts
Hey on my 9670 I was having a code mousture sensor stalled when I was harvesting wheat so it was getting wheat jammed around the plunger so I made up a 10 cent piece of stainless tin with a hole in it about a quarter in smaller than the plunger I installed this so when the plunger made the full stroke up it contacted this tin plate creating a seal so small grain or even weeds couldnt go by once it was ready to take sample plunger would move downward again pulling away from tin plate thus opening the rectangle hole allowing grain to fall i to tester its been working like a charm dealer wanted to sell me a 4300 dollar sensor try it i would send you a picture but its tide up right now
 

·
Registered
Joined
·
172 Posts
Go with trimming a inch to start with and if it's still plugging try take another inch. It's worked for me before on different units.
 
1 - 4 of 4 Posts
Top