The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
653 Posts
I worked on a 93 that was a custom cutters. The machine had a few hours over 9800. Customer said that was the third new tach put on the machine so he didn't know the real hours he was guessing around 14K. HE said he had put the sheet metal above the concave in 4 times. I went out to the service call for a no start complaint. Guy had about 15psi cylinder pressure. The machine was done.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top