[kingcotton]

gonna put an ez guide 500 in combine so i can have GPS for yield mapping. would like to have it in front of me so i could skip passes when cutting but not a must have. where have yall mounted it? thought about unbolting the mount where the pro 600 is and making a piece that came down lower than the 600 and put it there.

TIA

 

[8010when]

Not sure where the pro 600 is, but I put mine just to the left of the gauge pillar, screwed a ram mount right into the ceiling and away I went. Be sure to find the metal and not the wires when you go to drillin!

 

[kingcotton]

any pics? that is a good spot. i might try to put it there....


thanks.

 

[casefarmer]

yeah same here... can you take pic's and measure it out reall quick??? thanks

 

[2366man]

Yea i would like to see it to we are talking about putting our gps in the combine, thanks
Eric

 

[8010when]

Hey sorry guys I just check this board, but we sold our 2388 so pics can't be found. Sorry about that.

 

[8010when]

If i get some time I will try and take a pic of the cab of a combine on the dealer lot and point out where I put it though.

 

[casefarmer]

what did you trade for

 

[8010when]

We just got ourselves an 08 8010 with a Hillco leveler, it was a rental machine last year with 300 hours. Bought it with full factory warranty since we are first owners. Used price with new warranty, that sure seemed like a good deal.