[Ronen]

Hello

I need your help people
My problem in the tractor is when I start driving in the filed with the tractor, I use the clutch for the first time.
Then when I finish the row I stop put in "N", the wagon is been loaded.
Then when I want to start driving again, I am not supposed to use the clutch.
Just to push the push forward the stick lever and the tractor will start driving.
But it's not working, it's writing on the small screen "CP".
And after a few seconds going back to "N".
And I need to use the clutch again.
I don’t think the problem is in the micro switch.
I am not sure if the problem is in the analog sensor.
Do you have base on your experience advices for me?
Can you direct me to the part which is causing this problem?

 

[farmshop]

Were you able to go from n to forward with out clutch before? I dont believe our new holland tg 230 that is basically the same tractor will do that. I know that it wont coming out of park pretty sure not out of n either

 

[DaleJ]

The problem you have is often caused by a fault with the seat (operator presence) switch or the wiring for this switch. When working correctly you get the CP warning only after you have got out of the seat.
The wiring flexes a lot with the seat suspension and might have a visible break.

 

[lostcause]

my case tractors will do the same thing if you move the lever too slow or hold it up just a little bit from the bottom of the slot it don't take much, usually don't have much of an issue with it after a couple days of running.