The Combine Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello! I have a hydraulic cylinder that I believe was a lift cylinder for a combine. It was modified to be used on a monster truck. The cylinder body has a 2.5" diameter. And the piston rod has a diameter of 1.875". Does anyone out there know what this came off of?? *Note that the bottom rod mount is a custom add-on.
161263
161264
20201111_170530.jpg
 

·
Registered
Joined
·
1,393 Posts
Almost appears both the base and rod end have been somewhat modified.
I don't recall if Massey ever put anything on their cylinders, but it seems to me John Deere used to stamp numbers on some of theirs in that approximate location.
 

·
Registered
Joined
·
1,375 Posts
Looks like an MH stamped into it. If that is for Massey Harris, then you need to go back to a 72, 82, 92 or older I believe.
Probably best bet is to find an (old) combine junk yard and just go snooping.
 
1 - 7 of 7 Posts
Top