The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,056 Posts
Discussion Starter · #1 ·
try ur rotors at 1200, upper seive at 15mm, lower at 5-6mm. fan about 900. play with that pre seive, that makes a lot of difference.

is it showing high on the monitor? Did u get a bucketful from the machine while it was running?
 

·
Registered
Joined
·
3 Posts
Just bought a new CR9070 and can't get it to stop throwing over. Does anyone have the settings for Barley and Wheat? Used to have Tx66 but nothing seems to be the same as far as thought logic???
 

·
Registered
Joined
·
3 Posts
It was coming out the back you could see it on the ground. We took the rotor up to 1250 and that made a huge difference. thanks for the info and help
 

·
Registered
Joined
·
152 Posts
If bly is easy threshing then open up sieve's and pre sieve as far as your sample is getting a smile on your face after that look what coming out ,if your happy with that set your loss mon. accordingly and that is your max cap. for that combine . think every brand will have same problem in those conditions.
Think your engine load will be close to 70% . If you want more cap you have to pull wire's.

good luck Snorton.
 
1 - 4 of 4 Posts
Top