The Combine Forum banner
1 - 12 of 12 Posts

·
Super Moderator
Joined
·
4,228 Posts
I've run both the T slat and the new set-up, in the same combine, that test would wreck a T slat.
When you can keep the slats straight it's also much easier on the chains.
I assume the feeder was running at 520 minimum feeder shaft speed?

Don
 

·
Registered
Joined
·
400 Posts
Discussion Starter · #11 ·
they said that they tried it at several speeds and also at several positions, centered, next to center chain, and next to end chain
 
1 - 12 of 12 Posts
Top