The Combine Forum banner
1 - 14 of 14 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
What would be the price of a basic 9760 or 9770 Spreaders, singles ,High rate unloading Auger, high wear kit,
I notice this question has been asked regarding a loaded machine , but i am interested in the difference to a basic one
Price asked is for a Cash No trade
 

·
Registered
Joined
·
889 Posts
Haha, that is laughable. From what I hear wait until about mid june before pricing a combine, could be quite a bit cheaper.

I bet you those prices in that on-line price book never go down! Price book prices never diminsh, only increase and varying rates. Only way anything is going to be cheaper is if the dealers end up with unexpected "back-outs" on their lots that need to get resold and gone ASAP.
 

·
Registered
Joined
·
1,628 Posts
I bet you those prices in that on-line price book never go down! Price book prices never diminsh, only increase and varying rates. Only way anything is going to be cheaper is if the dealers end up with unexpected "back-outs" on their lots that need to get resold and gone ASAP.

Muddy, you are exactly right.
 

·
Registered
Joined
·
293 Posts
If you run all green then you can't get red to leave you alone, pretty sure it works vice/versa too. Sometimes when they deliver bad news they do it in person. I usually get one salesman during planting and then one salesman during harvest.
 

·
Registered
Joined
·
1,196 Posts
Can I ask, My father was a JD salesman for 16 years before he retired, he used to go out to his customers on the farm and visit with them, do they do the same in the States, when you are talking that kinda money, they should be chasing you for the deal, not you going to them, In fathers day some deals came down to throwing in JD coveralls for the guys on the farm just to get the deal even if it was 1/4 million £ deal, Just interested, Cheers.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top