The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Help please. I have an s3, automate, edrive tc, and raven 4400
It all works great until I try I second application in the same feild. I can't get it to map or engage. Unless I'm outside of the boundaries from the last time over. I've already deleted all my previous jobs. So I'm out of ideas.
 

·
Registered
Joined
·
28 Posts
Deleting the jobs, does not allow you to apply again. You need to clear the previous application from the AutoMate. You can do this through the S3 or the AutoMate, on the AutoMate screen press the down arrow while on the home screen. It should say start a new job and then press the return arrow ( very right ) then the down arrow again to change no to yes on the screen and then the right arrow again to confirm. Your screen should say deleting or clearing memory, this will allow you to spray the second application.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top