[rseventyone]

Considering ordering the Precision Farm Parts small seeds chaffer board and would like to hear from anyone who has one. Useful add on or useless gimmick? If you have a picture of how it mounts that would be great too. Thanks.

 

[Snipe]

I ran one on my R72 and I took it off, sample was dirty and it covered grain loss sensors. Thinking back I should have run max air on shoe.

 

[Okey]

I just put one on a r75 this winter but have no experience running it yet so can't comment on if it helps yet. I can tell you that it wasn't to hard to install once I phoned PFP and talked to one of the guys in the shop. The thing came with no pictures or instructions and I had never seen one installed before. Here is a picture if it helps to make your decision.

 

[rseventyone]

Thanks guys. Great pictures Okey. Makes sense now. Did the angle brackets on the side come from PFP? They look factory, but I'm pretty sure I don't have them on my 72.

 

[Snipe]

Thanks guys. Great pictures Okey. Makes sense now. Did the angle brackets on the side come from PFP? They look factory, but I'm pretty sure I don't have them on my 72.

They come with board. You can also attach your grain loss sensors to board if you want them to work.

 

[Okey]

They come with board. You can also attach your grain loss sensors to board if you want them to work.

X2. I never moved the sensors yet because I'm not sure if it is going to stay on. If it works I might move them but that creates a lot more work if I want to take it on and off. Gleaner's don't throw over anyway.