The Combine Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,142 Posts
Discussion Starter · #1 ·
we have been having trouble with our pro 600 screen on the 7010 just freezing.

it will just freez rock solid if you refresh it some times it will come good some time you have to stop the combine to reset it.

any one have a ideal dealer says its because of the auto steer
got a mate with a cr9060 having the same problem his dealer said the same as ours

thanks for your help
 

·
Premium Member
Joined
·
147 Posts
Hi,
We had one this fall that would freeze up now and then, took it in and had them remove the printer function on it. We were not using it and it takes up alot of memory, you can ask them what else you don't need and take that off as well. Your dealer should know what to take off to make it run better.
Curt
 

·
Registered
Joined
·
560 Posts
if you're running v21, run only the essential software. No E-Notes. That should resolve most of the issues.

If you want, you can have your dealer install v24 software.

As others have mentioned, this can also be caused by your datacard. Make sure it is CNH-approved (SanDisk, ATA Flash or CompactFlash, 32MB to 4GB). If it has a lot of data on it, it can take the display a while to read the data on startup, and the display will appear to be locked up while it reads.
 

·
Registered
Joined
·
1,142 Posts
Discussion Starter · #6 ·
thanks guys will set out to try work it out it not a big problem just some thing that gives you the sh1ts just keeps doing it we have a 128mb scandisk card in at the moment and it gets formated a few times a year
i will take it to town and get them to take all the stuff we don't use and see how it goes will let you know

Cheers roger
 
1 - 7 of 7 Posts
Top