The Combine Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
On header 1 I put in 36 ft for header width for target width
I put 35 ft but 29.53 is high as it will go any suggestions
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #3 ·
it just says version it dont have any numbers if you move over to can under the software version i think it says 31 1.5 0 i think on the ccm1 controler
 

·
Registered
Joined
·
560 Posts
On your Diagnostics > Version screen, it should list several pieces of software (Framework, Combine, Precision Farming, etc.) and their version numbers. This is the list I'm looking for.

The list of controllers and software shown on the CAN screen would also be good (CCM1, CCM2, CCM3).
 

·
Registered
Joined
·
560 Posts
you need to get updated to the latest display software (v21.x). Your dealer can take care of this for you, and will update your other controllers at the same time.

I don't think you'll see the header width problem after you update.
 

·
Registered
Joined
·
120 Posts
Discussion Starter · #6 ·
software says word version framework v16.4.0.0 bsp2.5.0.0 combine axial flow v16.3.0.0 precision farming v16.3.0.0 display faults v16.1.0.0 autoguidance v16.2.0.0 yeild v16.4.0.0
 
1 - 6 of 6 Posts
Top