The Combine Forum banner
1 - 3 of 3 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I'm replacing a Universal display + with a pro 600 monitor in a 2388. Is there a way to transfer calibration & set up to the pro 600 ? I believe I would have to convert the .vyg to .vy1. Desktop software is version 8.01. Have tried device setup utility & exported in the vy1 format with no luck. Any help appreciated. Thanks
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.