The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Can't get the Virtual Terminal for the Precsion Air Cart on the Pro 700 to show my cart speed. It always reads 0.0 mph. I did a distance calibration on the Virtual Terminal and the cart picked up targets as I was driving and displayed back "feet covered" after each target passed. I enter the actual feet in the box after I did the "go" "stop" travel procedure. A new distance calibration number approx 8,000 showed up on the screen after I entered the actual feet in the measurement box. Still 0.0 mph shows up on the screen.

Any suggestions would be appreciated.

:confused:
 

·
Registered
Joined
·
139 Posts
Make sure the sensor is adjusted correctly, its on the right rear of the cart. The factory call number is 92.3 and most of the time that is pretty darn close so your cal number of 8000 is way out of wack.

Jeff
 

·
Registered
Joined
·
15 Posts
what big block said. If its new it come no where near adjusted from factory. And the cart will not meter seed with out it showing speed.
 
1 - 3 of 3 Posts
Top