The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a Pro700 running our Flexicoil 5860 air cart. I had the cart updated to the latest software a couple weeks ago, yesterday I hooked it up and went to start seeding and I can not get the task controller to allow me to resume a task. I have spent hours at this point looking online and working through the system and I can’t get it to work, it’s like the TC is not even setup. Pretty frustrating to say the least and wondering if anyone else is having this issue with version 31.31.0.0.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
So the tech has been struggling with it too. I think it’s a missed setting somewhere in the product setup but neither of us could figure it out. I think he was just going to try and reinstall the previous version. I ended up getting a section control activation on a gen 4 John Deere display and I got it to work rather easily as it’s a John Deere tractor pulling the flexicoil. Just took time to setup all the sectional control delays and measurements again for the gen 4 display. At least it’s working now.
 
1 - 3 of 3 Posts
Top