Please call me. Donnie 765-258-4024
Problems putting Disrupters in JD 9870
Putting CM welding disruptors in a JD 9870, can't seem to get the #2 and #6 disrupter placed where tines won't rub or hit them. Using the ones with short leg like instructions says. Looks to me like short leg is on wrong side of disruptor. Tines would go over it if short leg was on other side. Anyone else had this problem?
1 - 3 of 3 Posts
Got disruptors and concaves in. Donnie has been a stand up guy in answering questions and helping with installation. Looking forward to trying them out. Thanks again for your help Donnie!
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Combine Forum
A forum community dedicated to all combine owners and enthusiasts. Come join the discussion about specifications, accessories, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
