The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter · #1 ·
I run a 91 1660 in corn and soybeans. Standard rotor, factory setup. I've never pulled any wires out of the concaves. How do most of you run yours? How many wires do you pull out and on which concaves. Refresh my memory on the disadvatages of pulling the wires out.

Thanks,

Brandon
 

·
Registered
Joined
·
105 Posts
Leave all wires in front concave, pull every other wire on rear half of middle concave and rear concave. This is optimum set-up for corn/soybeans. There are no disadvantages, other than you will embarrass your john deere neighbor at the elevator with your sample.
 
1 - 2 of 2 Posts
Top