The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 · (Edited)
The bearing on the left side of my gleaner on the main shaft decided to pack it in on me. I have it all tore down except I have to get the race off of the main shaft. I see it has two threaded holes for set screws, but has no set screws in it. The other thing that I have noticed is that I don't know how to tighten the set screws on the new bearing since they will be behind the housing. There is another post on here for an S77 saying not to used the set screws. Am I not seeing something? Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top