The Combine Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
Could someone running an 8 30 fantini chopping head on a similar gleaner, get me a measurement on the FEMALE half of the pto shaft on the left hand side of the head? Measurement should be from the roll pin connecting the shaft to the yoke, to the end of the shaft. Female half of pto is the half that connects to header drive on my combine.
Trying to find out if I have right one to provide enough overlap of shaft halves.
TIA
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top