The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
My grain loss monitor won't register on any setting. I turned it to test and checked the pads on the shoe and only the outside ones lit up. When I'm cutting I can't get any thing to light up. Any suggestions where to start?
 

·
Registered
Joined
·
1,276 Posts
They should be working if the good during the test. If center sensor is dead i would suggest the harness has broken wire in the harness. Check for very localized bending of harness at right rear hanger of shoe support. If you have shoe loss it is blowing it over the sensors
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top