The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter · #1 ·
Re: 2188 ?

smz, sounds like you did alright. One thing you may want to check is the engine fan hub. Pop the serpentine belt off and pull on the fan, if you feel any movement replace it. Chances are it has been done already with the hours it has. If it still has paint on it then it is safe to say it is original, I would change it. It is a pain to do but is alot cheaper than a radiator. Good luck.
 

·
Registered
Joined
·
137 Posts
Discussion Starter · #6 ·
Re: 2188 ?

you may want to consider upgrading the shaker rail to the cast web shaped as shown in phillphy's pictures (if not already done). On the unload auger remove the access panel by the elbow and inspect the rivets inside the elbow and vertical tube, when they wear off the auger can fall off. This would be more of an issue if a lot of dirt has been ran through it.
 
1 - 2 of 2 Posts
Top