The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
508 Posts
Discussion Starter #1
Re: 925 header and auger problems

So no one else at that dealership can work on 9600 combines? Kinda find that hard to believe. All they have to do is get the manuals out. Ask for the manual from the dealer. If they won't give ya it then call another JD dealer. Check fuses, bleed the lines.

Take care,

Nathan
 

·
Premium Member
Joined
·
1,236 Posts
Re: 925 header and auger problems

The mice could have got to your combine and was eating on your wires or if it was outside lighting could of hit it. Look at your wire harness on both sides, at the engine, inside the cab on the right side, there is a cover that the wire harness goes into the cab on the right side. Also look at your circuit board.
 
1 - 2 of 2 Posts
Top