The Combine Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter · #1 ·
Re: 9760 spreading problem

Do you have a chopper or spreader or the powercast spreader?

Any wind?

Have you messed with the chopper vanes yet?
 

·
Super Moderator
Joined
·
3,927 Posts
Re: 9760 spreading problem

bdkalt this is the nature of the beast (which usually means you can't do anything about it) but I also would be interested in any suggestions to even the spread.
green lights.
 

·
Registered
Joined
·
2,199 Posts
Re: 9760 spreading problem

Quote:We donnt have a spreader but i havent messes with the vanes yet. It looked like they were pretty much equal. I wouldnt think those would make it throw more to one of the far sides. Ill try adujusting them and see what it does.

Could it be that the straw coming out of the rotor cage gets mostly dumped on the left side, thus more of it goes left with the veins?

-Lance
 

·
Super Moderator
Joined
·
3,927 Posts
Re: 9760 spreading problem

Lance that is exactly the case. There are 2 fins on the discharge beater plate but they just don't 'cut it' in evening the flow. (O that was bad) Additionally conditions dictate wildly flows into the chopper,
no easy,simple, across the board solution.
Green lights.
 
1 - 4 of 4 Posts
Top