The Combine Forum banner
1 - 1 of 1 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
Hello, I have a rem 2100 grain vac and I am having a problem getting the top section of the auger to lock out. It pushes out about 1" short of locking with a tight seal. It also does not stay tucked in when putting it down, it flops out, but will go back with little effort by hand. I have pressure checked the cylinder the section is on and it has to sign of leaking seals. What next?

PS. the bottom cylinder works fine.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.