The Combine Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,118 Posts
Discussion Starter #1
Case Prototype(s)
http://www.combineforums.proboards42.com....read=1188840923

Attention: All 03-06 8010 owners
http://www.combineforums.proboards42.com....read=1183686062

7010 & 8010 Repair/Maintenance Tips thread
http://www.combineforums.proboards42.com....read=1168838264

Axial-flow Add-on parts thread
http://www.combineforums.proboards42.com....read=1167580684

Axial-flow Repair/Maintenance Tips thread
http://www.combineforums.proboards42.com....read=1157306402

If you have another topic you feel should be included in this thread, just PM me a link and I'll add it to it. Thanks, Alex
 

·
Premium Member
Joined
·
204 Posts
Does anyone know where you can get the 'adjustment slide ruler' for AFX combines? We had one for our 2188, but don't know how to get one for the AFX combines (8010). It shows one in the productivity guide on the case ih website that you can download.
 

·
Registered
Joined
·
1 Posts
I have a '25 1020 flex head with a pro drive knife drive, we ordered skid plates for the drive side but were sent the wrong ones is there a difference between pro drive skid plates and case ih drive?
 

·
Registered
Joined
·
5 Posts
Here is a important tip do not run a 03 to 07 8010 with a bad alternator. Voltage drops below 10.3 volts will cause your engine ecm to be dammaged. Of your alt quits stop shut down and turn it off.
 

·
Registered
Joined
·
100 Posts
Had hard steering on my 2388- greased the living heck out of the rear wheel pins while someone turned the steering wheel- it worked. They took grease hard in the first place though.
 
1 - 7 of 7 Posts
Top