The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
922 Posts
Discussion Starter · #1 ·
I broke my bolts on my concave not sure how I did that. I had it really open cutting camalina with weeds on my cousins place not sure if I had it too open so material would not flow very well or just to much green weeds? ( anyways I told him to swath the rest) so anyway the center bed wiped out a foot of flighting maybe 18" anyways is there an easy way of getting the auger out? or should I make sure that my insurance is paid up put the flighting and weld in place. thanks for any advice
 

·
Registered
Joined
·
1,982 Posts
not a real big chore, close your chaffer and crawl in with a roll pin punch. Drive out the roll pin(s) for the affected augers. then you take off the wood block under the feeder house and spin the auger out through the larger slot. Shouldn't be too hard if the flighting isn't really bent. Oh and put a new bearing in the top while you have it out, just my .02
 
1 - 2 of 2 Posts
Top