The Combine Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Looking for a little assistance on how to replace the king pin bushings on my 2366 steering axle.

If anyone has had to do this or can give me some tips it would be greatly appreciated.

One major question I have is:
In order to remove it, does the king pin drive up from the bottom or down from the top?
 

·
Registered
Joined
·
25 Posts
I just replaced mine on a 1680 before fall and it wasn't a bad job, might be differnt thought for a 2366. If I remember right the pin drives up from the bottom (pull out through the top). The bushings I had to cut out with a saw-zaw I couldn't get anything to drive them out (or figured this was a quicker and easier way). Either way I think it took me a few hours to do both sides. One thing I do remember was those bushings are not cheap!!!


Good luck
 
1 - 5 of 5 Posts
Top