The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
The main cutter bar broke ( not the sickle) on our 1991 1020 at the knife head . We weled it to get done but it is not right . found out the bolts that mount to the angle on the back of the wobble box that the bolts had wore the heads off and pulled through Can we change the bar and gauards or call it junk?
 

·
Registered
Joined
·
132 Posts
I had a 1993 1020 30' that I replaced the cutter bar on after I bent it severely. Two people did it in an afternoon, just a lot of bolts to take out. An impact wrench speeds up the process.
 
1 - 2 of 2 Posts
Top