The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,246 Posts
Discussion Starter · #1 ·
I have an 8' rhino cutter/mower that on my 4020. While clipping some crp ground the cutter would stall and I'd have to lift it to clean out and regain speed. Well I figured the clutch was starting to slip and when I shut the tractor down, I was right. It's pretty heavy fescue and weeds so I was clipping it at about 8". Any suggestions on tightening the clutch?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top