No more Wardale Equip...
http://investors.rockymtn.com/releasedetail.cfm?ReleaseID=476135
http://investors.rockymtn.com/releasedetail.cfm?ReleaseID=476135
Rocky Mountain Dealership expands
1 - 3 of 3 Posts
Joined
·
236 Posts
We have been dealing with Millers in Dauphin since they opened and really havent seen much change since the Rocky takeover. Same staff(they did loose a really good service mgr just befor the takeover.. Heritage is a good guy and I bet Warren will stay on as store manager in Yorketon. Wouldnt be too concerned.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
CASE-IH 1660- Concave adjustment ratchet lever-anything better??
Case IHAnyone found anything better then the factory ratchet lever for the concave adjustment? Mine has always been very hard to flip the direction lever on, works better for a little while if you blow it out and lube it up good, but it never works decent for very long. A new one is $143.00, which I...- 2
- 164
-
6140 xflow cleaning
Case IHI need advice for a new combine (no hill only flat land).. actually have a 2388. Are the bushing in the midrange 140 serie combine with the new Xflow cleaning system really beefed up ? Is the Xflow cleaning system reliable or it's better to stay with the old fashionned cleaning system with...- 2
- 331
-
Canola settings 8230 flagship
Case IHG’day all after some settings for haversting windrowed canola. Crop yield is around 2.5T to the ha. With reasonable grain weight. Current settings are. Concaves large, small, slot, slot. Rotor speed 580. Fan speed 650, pre sieve 2, upper 10 lower 8. Can’t seem to get the capacity out of the...- 7
- 486
-
Sam Badger · updated
-
8240 issues
Case IHHad our 8240 for 5 seasons now and have had our fair share of issues with the thing. Wanted to get an idea from others if we're an outlier or if this is standard with Case combines? We ran CRs previously. 2200 engine 1600 rotor Overheating hydro issues first season Feeder house drive shaft bad...- 12
- 687
-
header height cont
Case IHwhat potentiometer part number is correct for a older 1020 header on a 2166. We were sent a 127360A2. Its not working. The prev owner said the combine was working with his header. Our header was working correct on a 1440, but we were told we needed a different potentiometer for the 2166. someone...- 3
- 272
Join now to ask and comment!