The Combine Forum banner
1 - 1 of 1 Posts

· Registered
94 Posts
Discussion Starter · #1 ·
Working on my 1480 and the extensions on the rear of the rotor which I assume are for kicking the straw down and into the beater/discharge area. Is there a setting for these? I have the orginal ones that look like a piece of 3 x3 angle iron but they only stick past the rotor end by about a inch or so. I have another set which seem lighter 3 x1 angle that look like they'd bolt to the orginal which would project them past the rotor end by say 4 to 6 inches. I've looked in my owners manual and there is no reference to these extensions nor info on setting them up. Can anyone shed some light on this for me?

Thanks in advance, Weapon
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.