The Combine Forum banner
1 - 2 of 2 Posts

· Registered
32 Posts
Discussion Starter · #1 ·
Having problems with rotor loss in 3000 lbs canola with 9660sts, can only reach 2 mph. Have two narrow wire concaves in the first two positions and one wide wire concave in the rear. Concave clearance is at 19 and rotor speed is at 650 (standard rotor) and I have the separator grates installed to balance the chaff load on the shoe. Thanks in advance.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.