The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
Ran my round bar conclaves for the first time yesterday. Should have bought them last year. Much much less fines in the corn and less power consumption. I need to slow down the concave vanes a little since I seem to be putting a little out the back. They are well worth the $$.
 

·
Registered
Joined
·
59 Posts
I had round bars. I went to the new "RPR Concaves" from CM Welding right at end of corn harvest and rotor loss went down. They did a great job in soybeans with the cover plates on. If they work in milo next year, no more changing concaves.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top