The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,073 Posts
Discussion Starter · #1 ·
Can't seem to get the return to cut to work properly on our 23 .IT seems to work on the straight head but when I put the pickup head on I can adjust it so the little arrow shows then the head runs up about a foot . Even with the straight head on it never seems to want to lower to the same height that well . have changed the potentiometer with another one and same thing . And where is the control module located as I've got another combine that I can use to switch parts . Any ideas ???
 

·
Registered
Joined
·
44 Posts
have to calibrate every time you change heads. book tells you how, but just lower head to ground and hold down button for 2-3 seconds at minimum position.
 
1 - 2 of 2 Posts
Top