The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Got done with beans in hi gear, switched to low for corn and the heads up display starts with a green hi-lite light then in 30 seconds shows red and beeps. Says slow cylinder, da, running at 300 rpm.Sensor is fine in high gear, is it the sensor?
 

·
Registered
Joined
·
18 Posts
Have your reset the shaft alarm after reducing your cylinder speed from beans to corn? Set you cylinder speed for corn, push the icon for the rotor speed on the EIP (heads up display) and then hit the o.k. button. It will reset the alarm for the new rotor speed. You will need to do this also for your straw chopper after going from high to low.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top